Fujitsu FLASH-CAN-100 User Manual
Change odd page title here
Chapter 5 Configuration of the Evaluation-Board
© Fujitsu Microelectronics Europe GmbH
- 11 -
UG-900001-32
7. Select the appropriate UART interface for the microcontroller you are using by setting
jumper JP7-JP10.
8. Please use 1:1 cable for PC-connection.
Notes:
<
Pixx on the silk plot stands for Pinxx, i.e. the pin number.
e.g. for the MB90F598, set JP10 and JP9 to connect Pin 1 and 2 in order use UART 1
e.g. for the MB90F598, set JP10 and JP9 to connect Pin 1 and 2 in order use UART 1
<
MB90425, MB90470, MB90480 and MB90580 series are not supported by jumpers.
Please make handwired connections for these controllers.
Please make handwired connections for these controllers.
Target Series
Asynch.
Com.
SIN / Jumper
SOT / Jumper
handwire Pin 88 – JP10.2
handwire Pin 89 – JP9.2
MB90425 UART1
(Not supported by Jumper JP7 - JP10)
MB90435
UART1
Pin 21 (JP10:1-2)
Pin 24 (JP9:1-2)
MB90440
UART1
Pin 21 (JP10:1-2)
Pin 24 (JP9:1-2)
handwire Pin 27 – JP10.2
handwire Pin 28 – JP9.2
MB90470 UART0
(Not supported by Jumper JP7 - JP10)
see chapter 6.1 !
handwire Pin 27 – JP10.2
handwire Pin 28 – JP9.2
MB90480 UART0
(Not supported by Jumper JP7 - JP10)
see chapter 6.1 !
MB90540
UART1
Pin 21 (JP10:1-2)
Pin 24 (JP9:1-2)
MB90545
UART1
Pin 21 (JP10:1-2)
Pin 24 (JP9:1-2)
MB90550
UART0
Pin 20 (JP8:1-2)
Pin 19 (JP7:1-2)
handwire Pin 18 – JP10.2
handwire Pin 19 – JP9.2
MB90580 UART0
(Not supported by Jumper JP7 - JP10)
MB90590
UART0
Pin 16 (JP8:2-3)
Pin 14 (JP7:2-3)
MB90595
UART1
Pin 21 (JP10:1-2)
Pin 24 (JP9:1-2)
Table 2: MCU pin-number used, for the asynchronous boot-loader software