Manualsbrain.com
  1. Manuals
  2. Brands
  3. MGE UPS Systems
  4. Switched PDU
  5. User Manual

MGE UPS Systems Switched PDU User Manual

Download
Page of 62
 
 
3. Operations 
Displaying network configuration information 
The Show Network command displays TCP/IP, Telnet, SSH, Web, SSL and SNMP configuration information.  
• 
IP address, subnet mask and gateway 
• 
Enabled-disabled status of Telnet, SSH, HTTP,SSL and SNMP support 
• 
Telnet, SSH, and HTTP port numbers 
• 
HTTP authentication method and SSL access setting 
• Network 
status 
See page 47 for more information on SNMP. 
To display network configuration information: 
At the Switched PDU: prompt, type 
show network
 and press 
Enter
. 
Example 
The following command displays the network configuration information: 
Switched PDU: show network<Enter> 
   Network Configuration 
      IP Address:    12.34.56.78 
      Subnet Mask:   255.0.0.0 
      Gateway:       12.34.56.1 
      Telnet:        Enabled       Port:    23 
      SSH:           Enabled       Port: 65535 
      HTTP:          Enabled       Port:    80     Security: BASIC 
      SSL:           Enabled                       Access:   Required 
      SNMP:          Enabled 
   Network Status 
      Link:          Up 
      Speed:         100 Mbps 
      Duplex:        Full 
      Negotiation:   Auto 
HTTP Administration 
NOTE:  A restart is required after setting or changing ANY Telnet/Web configurations.  See Performing a warm 
boot on page 39 for more information.  
Enabling and disabling HTTP support 
The Set HTTP command is used to enable or disable HTTP support. 
To enable or disable HTTP support: 
At the Switched PDU: prompt, type 
set http
, followed by 
enabled 
or 
disabled
 and press 
Enter
. 
Changing the HTTP server port 
With HTTP support enabled, the HTTP server watches and responds to requests on the default HTTP port number 80.  
This port number may be changed using the Set HTTP Port command.  
To change the HTTP port: 
At the Switched PDU: prompt, type 
set http port
, followed by the port number and press 
Enter
. 
Example 
The following changes the HTTP port number to 2048: 
Switched PDU: set HTTP port 2048<Enter> 
Page 40 - 301-0399-4 Rev A.