Manualsbrain.com
  1. Manuals
  2. Brands
  3. MGE UPS Systems
  4. Switched PDU
  5. User Manual

MGE UPS Systems Switched PDU User Manual

Download
Page of 62
   
3. Operations 
 
Displaying the firmware version 
The Version command displays the firmware version. 
To display the firmware version: 
At the Switched PDU: prompt, type 
version
 and press 
Enter
. 
Performing a warm boot 
The Restart command performs a warm boot of the Switched PDU. 
NOTE:  System user/outlet/group/port configuration or outlet states are NOT changed or reset with this 
command. 
To perform a warm boot: 
At the Switched PDU: prompt, type 
restart
 and press 
Enter
. 
TCP/IP Administration 
NOTE:  A restart of the Switched PDU is required after setting or changing ANY TCP/IP configurations.  See 
Performing a warm boot  for more information. 
Setting the IP address 
The Set Ipaddress command sets the TCP/IP address of the network interface controller. 
To set the IP address: 
At the Switched PDU: prompt, type 
set ipaddress
, followed by the IP address and press 
Enter
. 
Example 
The following command sets the IP address to 12.34.56.78: 
Switched PDU: set ipaddress 12.34.56.78<Enter> 
Setting the subnet mask 
The Set Subnet command sets the subnet mask for the network the PT40 will be attached to. 
To set the subnet mask: 
At the Switched PDU: prompt, type 
set subnet
, followed by the subnet mask and press 
Enter
. 
Example 
The following command sets the subnet mask to 255.0.0.0 
Switched PDU: set subnet 255.0.0.0<Enter> 
Setting the gateway 
The Set Gateway command sets the IP address of the default gateway the Switched PDU uses to access 
external networks. 
To set the gateway IP address: 
At the Switched PDU: prompt, type 
set gateway
, followed by the gateway IP address and press 
Enter
. 
Example 
The following command set the gateway IP address to 12.34.56.1: 
Switched PDU: set gateway 12.34.56.1<Enter> 
301-0399-4 Rev A. - Page 39