MGE UPS Systems Switched PDU User Manual

   

4. Advanced Operations 

SNMP 

The Switched PDU family of products supports the Simple Network Management Protocol (SNMP).  This allows 
network management systems to use SNMP requests to retrieve information and control power for the 
individual outlets. 

The Switched PDU includes an SNMP v1 agent supporting standard MIB I and MIB II objects.  A private 
enterprise MIB extension is also supported to provide remote power control. 

NOTE:  For security, SNMP support is disabled by default. 

Set snmp 

Enables or disables SNMP support 

Set snmp getcomm 

Sets the ‘get’ community string 

Set snmp setcomm 

Sets the ‘set’ community string 

Set snmp trapdest1 

Sets a destination IP addresses for traps 

Set snmp trapdest2 

Sets a destination IP addresses for traps 

Set snmp traptime 

Sets the delay for steady state condition traps 

Show snmp 

Displays all SNMP configuration information 

Switched PDU SNMP support must be enabled and configured for access to Switched PDU3 MIB objects and 
generation of all Switched PDU3 traps.   

The Switched PDU SNMP command is used to enable or disable SNMP support. 

At the Switched PDU: prompt, type 

, followed by

 or 

 and press 

. 

NOTE:  A restart of the Switched PDU is required after enabling or disabling SNMP support.  See Performing a 
warm boot on page 39 for more information. 

301-0399-4 Rev A. - Page 47