MGE UPS Systems 3000 RT 3U XL User Manual

34007776EN/AB

 - Page 12

2. Installation

HotSwap MBP-module operation

  

1 - Check that the UPS is correctly connected to the HotSwap MBP module.
2 - Set switch (53) to the Normal position.
3 - Start the UPS by pressing the ON/OFF button (27) on the UPS control panel. 
The load is supplied by the UPS.
LED (51) "UPS ON - OK to switch" on the HotSwap MBP module goes ON.

1 - Set switch (53) to the Bypass position and check that the load is still supplied.
2 - Set switch (53) back to the Normal position.

2.7 UPS connection without a FlexPDU or HotSwap MBP module

   

 The 

HotSwap MBP module has a rotary 

switch (53) with two positions:
Normal - the load is supplied by the UPS,
Bypass - the load is supplied directly by the 
AC-power source.

   

  

    

1 - Connect the supplied cable (31) (250 V - 
16 A) to the socket (10), then to the AC-power 
source.
2 - Connect the loads to the UPS using the 
cables (32).
It is preferable to connect the priority loads to 
the four outlets marked (9) and the non-
priority loads to the four outlets marked (8) 
that can be programmed in pairs (1 and 2).
Connect any high-power devices to the 16 A 
outlet (7).

  

To program shutdown of outlets (8) during 
operation on battery power and thus optimise 
the available backup time, the MGE UPS 
SYSTEMS communications software is 
required.

3 - Fit the connection securing system (35) 
that prevents the plugs from being pulled out 
accidentally.

  

Note. The UPS charges the battery as soon as it is connected to the AC-power source, even if button (27) is not pressed.
Once the UPS is connected to the AC-power source, eight hours of charging are required before the battery can 
supply the rated backup time.