3M 10700 User Manual
15
Installation and Setup
(Continued)
2.
Verify that the upper and lower taping heads
move freely by pushing the buffing roller into the
taping head.
move freely by pushing the buffing roller into the
taping head.
3.
Using a 10 mm open-end wrench, loosen the
capscrew on the tape drum bracket assembly
and move the assembly to the vertical position,
as shown in Figure 2-9. Install additional
capscrews from the tool kit. The tape drum
bracket assembly can be pivoted as necessary
to provide tape roll clearance from the floor or
overhead obstacles.
capscrew on the tape drum bracket assembly
and move the assembly to the vertical position,
as shown in Figure 2-9. Install additional
capscrews from the tool kit. The tape drum
bracket assembly can be pivoted as necessary
to provide tape roll clearance from the floor or
overhead obstacles.
1.
Cut the plastic ties holding the upper and lower
taping heads in position, as shown in Figure 2-8.
Hold taping head Buffing Roller while cutting the
plastic tie. Allow buffing/applying arms to extend
slowly.
taping heads in position, as shown in Figure 2-8.
Hold taping head Buffing Roller while cutting the
plastic tie. Allow buffing/applying arms to extend
slowly.
Figure 2-8—Cut the Plastic Ties
Figure 2-9—Lower Tape Drum Bracket Position
INITIAL STARTUP OF CASE SEALER
After completing the "Installation and Setup"
procedure, continue through "Operation" for tape
loading and startup to ensure that the case sealer
is properly adjusted to run boxes.
procedure, continue through "Operation" for tape
loading and startup to ensure that the case sealer
is properly adjusted to run boxes.
TAPING HEAD SETUP