Cisco Systems 3130 User Manual
39-21
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 39 Configuring IPv6 Unicast Routing
Configuring IPv6
Beginning in privileged EXEC mode, follow these required and optional steps to configure IPv6 RIP:
To disable a RIP routing process, use the no ipv6 router rip name global configuration command. To
disable the RIP routing process for an interface, use the no ipv6 rip name interface configuration
command.
disable the RIP routing process for an interface, use the no ipv6 rip name interface configuration
command.
This example shows how to enable the RIP routing process cisco, with a maximum of eight
equal-cost routes and enable it on an interface:
Switch(config)# ipv6 router rip cisco
Switch(config-router)# maximum-paths 8
Switch(config)# exit
Switch(config)# interface gigabitethernet0/11
Switch(config-if)# ipv6 rip cisco enable
For more information about configuring RIP routing for IPv6, see the “Implementing RIP for IPv6”
chapter in the Cisco IOS IPv6 Configuration Library at this URL:
chapter in the Cisco IOS IPv6 Configuration Library at this URL:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ipv6 router rip name
Configure an IPv6 RIP routing process, and enter router
configuration mode for the process.
configuration mode for the process.
Step 3
maximum-paths number-paths
(Optional) Define the maximum number of equal-cost routes
that IPv6 RIP can support. The range is from 1 to 64, and the
default is four paths.
that IPv6 RIP can support. The range is from 1 to 64, and the
default is four paths.
Step 4
exit
Return to global configuration mode.
Step 5
interface interface-id
Enter interface configuration mode, and specify the Layer 3
interface to configure.
interface to configure.
Step 6
ipv6 rip name enable
Enable the specified IPv6 RIP routing process on the interface.
Step 7
ipv6 rip name default-information {only |
originate}
originate}
(Optional) Originate the IPv6 default route (::/0) into the RIP
routing process updates sent from the specified interface.
routing process updates sent from the specified interface.
Note
To avoid routing loops after the IPv6 default route (::/0)
is originated from any interface, the routing process
ignores all default routes received on any interface.
is originated from any interface, the routing process
ignores all default routes received on any interface.
•
only—Select to originate the default route, but suppress all
other routes in the updates sent on this interface.
other routes in the updates sent on this interface.
•
originate—Select to originate the default route in addition
to all other routes in the updates sent on this interface.
to all other routes in the updates sent on this interface.
Step 8
end
Return to privileged EXEC mode.
Step 9
show ipv6 rip [name] [interface interface-id]
[database] [next-hops]
[database] [next-hops]
or
show ipv6 route rip [updated]
Display information about current IPv6 RIP processes.
Display the current contents of the IPv6 routing table.
Step 10
copy running-config startup-config
(Optional) Save your entries in the configuration file.