Cisco Systems 3130 User Manual

Page of 1226
 
44-2
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 44      Configuring IP Multicast Routing
Understanding Cisco’s Implementation of IP Multicast Routing
Understanding Cisco’s Implementation of IP Multicast Routing
The Cisco IOS software supports these protocols to implement IP multicast routing: 
Internet Group Management Protocol (IGMP) is used among hosts on a LAN and the routers (and 
multilayer switches) on that LAN to track the multicast groups of which hosts are members.
Protocol-Independent Multicast (PIM) protocol is used among routers and multilayer switches to 
track which multicast packets to forward to each other and to their directly connected LANs. 
Distance Vector Multicast Routing Protocol (DVMRP) is used on the multicast backbone of the 
Internet (MBONE). The software supports PIM-to-DVMRP interaction.
Cisco Group Management Protocol (CGMP) is used on Cisco routers and multilayer switches 
connected to Layer 2 Catalyst switches to perform tasks similar to those performed by IGMP. 
 shows where these protocols operate within the IP multicast environment.
Figure 44-1
IP Multicast Routing Protocols
According to IPv4 multicast standards, the MAC destination multicast address begins with 0100:5e and 
is appended by the last 23 bits of the IP address. For example, if the IP destination address is 239.1.1.39, 
the MAC destination address is 0100:5e01:0127.
A multicast packet is unmatched when the destination IPv4 address does not match the destination MAC 
address. The switch forwards the unmatched packet in hardware based the MAC address table. If the 
destination MAC address is not in the MAC address table, the switch floods the packet to the all port in 
the same VLAN as the receiving port. 
This section includes information about these topics:
Host
Host
PIM
IGMP
CGMP
DVMRP
Internet 
MBONE
Cisco Catalyst switch
(CGMP client)
44966