Enterasys Networks 2200 User Manual
Connecting to the Network
3-8
Installation
Figure 3-5
2H258-17R Rear View
2. Observe the LANVIEW LEDs. After a successful boot, the PWR LED turns ON (green). If the
PWR LED is amber, there is no power redundancy. Check the power cord connections and the
power source. If there are no problems with the power cord connections or power source and the
PWR LED is still amber, contact Enterasys Networks. Refer to
power source. If there are no problems with the power cord connections or power source and the
PWR LED is still amber, contact Enterasys Networks. Refer to
3.4
CONNECTING TO THE NETWORK
This section provides the procedures for connecting fiber optic segments from the network or other
devices to the 2H258-17R.
devices to the 2H258-17R.
Ports 1 through 16 on the 2H258-17R have MT-RJ connectors for multimode fiber optic cable
connections.
connections.
NOTE: If the 2H258-17R is being installed in a network using SmartTrunking, there are
rules concerning the network cable and port configurations that must be followed for
SmartTrunking to operate properly. Before connecting the cables, refer to the
SmartTrunk User’s Guide for the configuration information.
rules concerning the network cable and port configurations that must be followed for
SmartTrunking to operate properly. Before connecting the cables, refer to the
SmartTrunk User’s Guide for the configuration information.
Primary
Redundant
26001-06
AC outlets are
on separate circuits