Siemens 6ED1050-1AA00-0BE8 User Manual
Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 04/2011, A5E03556174-01
Manual, 04/2011, A5E03556174-01
107
3.7.10
Correcting programming errors
Programming errors can be corrected easily in LOGO!:
● Provided editing mode is not yet closed, you can revert by one step by pressing ESC.
● If you have already configured all inputs, simply reconfigure the faulty input:
1. Move the cursor to the faulty position
2. Change to editing mode. Press OK
3. Enter the correct input circuit
You can only replace a block with a block that has exactly the same number of inputs.
● Provided editing mode is not yet closed, you can revert by one step by pressing ESC.
● If you have already configured all inputs, simply reconfigure the faulty input:
1. Move the cursor to the faulty position
2. Change to editing mode. Press OK
3. Enter the correct input circuit
You can only replace a block with a block that has exactly the same number of inputs.
However, you can delete the old block and then insert a new one. You can choose any new
block.
3.7.11
Selecting analog output values for RUN/STOP transition
You can select the analog values that are output at the two analog outputs when LOGO!
changes from RUN mode to STOP mode.
In the programming menu:
In the programming menu:
0VJ&RQILJ
3DVVZRUG
&OHDU3UJ
!(GLW
1. Move the ">" cursor to "
①
": Press or
2. Select "
①
": Press OK
3. Move the ">" cursor to 'AQ': Press or
4. Select "AQ": Press OK
5. Move the ">" cursor to "
4. Select "AQ": Press OK
5. Move the ">" cursor to "
②
": Press or
$47\SH
!$4LQ6WRS