Fujitsu RX200 User Manual
Options Guide
23
Processors
Installing a second processor
Installing the heat sink
Figure 10: Installing the heat sink
Ê
Fit the heat sink on the processor such that the side labeled “FRONT” (see
arrow (1) in figure above) is facing the front of the server.
arrow (1) in figure above) is facing the front of the server.
Ê
Attach the heat sink with four screws. Tighten the screws in diagonally
opposite sequence (2).
opposite sequence (2).
V
CAUTION!
Never install a processor without a heat sink! The processor is likely to
overheat, which may cause damage to the processor and the system
board.
overheat, which may cause damage to the processor and the system
board.
Installing the ventilation duct
Ê
Reinstall the ventilation duct (see page 20).
Ê
Close the server, plug in the power plugs, and switch on the server as
described in the chapter “Completion” on page 45.
described in the chapter “Completion” on page 45.
2
1