Fujitsu RX200 User Manual
Options Guide
43
9
RemoteView Components
V
CAUTION!
Please observe the safety information in the chapter “Safety Instructions”
on page 9ff.
on page 9ff.
9.1
Installing the RemoteView Service Board
S2 LP
S2 LP
I
How to install/remove and configure the RSB S2 LP is described in detail
in the manual “RemoteView Service Board S2/S2 LP 1.x, Mounting and
Setting Up”.
in the manual “RemoteView Service Board S2/S2 LP 1.x, Mounting and
Setting Up”.
The RemoteView Service Board S2 LP (RSB S2 LP) is a PCI board including a
completely independent system, i.e. it has a separate operating system with a
Web server and SNMP agent and can be driven by an external power supply.
completely independent system, i.e. it has a separate operating system with a
Web server and SNMP agent and can be driven by an external power supply.
The RSB S2 LP should preferably be installed in the low-profile PCI slot, but can
also be installed in the full-height slot.
also be installed in the full-height slot.
It is connected to the system board via a data cable and a power cable. The
RSB S2 LP enables remote diagnostics for system analysis, remote system
configuration, and a remote restart if the operating system fails or if a hardware
error occurs.
RSB S2 LP enables remote diagnostics for system analysis, remote system
configuration, and a remote restart if the operating system fails or if a hardware
error occurs.
Ê
Open the server as described in the chapter “Preparation” on page 15f.
Ê
Remove the riser card holder (see page 40).
Ê
Plug the supplied power cable into the J302 connector on the RSB S2 LP.
Ê
Plug the supplied data cable into the J104 connector on the RSB S2 LP.