Nortel Networks 1000M User Manual

 Installing a Signaling Server

NN43021-310

Standard 02.01

December 2007

Before you begin, make sure the DTE–DTE null modem cable (supplied with 
the Signaling Server) runs between the serial port on the back of the Signaling 
Server and the maintenance terminal.

Make sure the Signaling Server is powered up and connected to the 
maintenance terminal. Refer to Signaling Server: Installation and 
Commissioning (NN43001-312).

The Signaling Server must boot successfully before the user can log in.

Press <CR> to invoke the login prompt.

Enter the login credentials by doing one of the following:.

•

If the Signaling Server has connected to the Call Server (the startup 
messages indicate if the PBX link is up), use the PWD1 login to 
access the Signaling Server.

•

If the Signaling Server is not connected to the Call Server:

Enter the default Signaling Server Command Line Interface 
(CLI) login 

.

Enter the Signaling Server Command Line Interface (CLI) 
password. 

•

If this Signaling Server has just been installed and you are 
logging in for the first time, enter the default password 

.

The system immediately prompts you to change the default 
password. 

•

If this is not the first login to the Signaling Server, enter the 
appropriate password. 

If you have forgotten the password, reset it from the Tools 
Menu (see Signaling Server: Installation and 
Commissioning (NN43001-312)).

To log out of the Signaling Server, enter 

 at the command line.