Hand Held Products 2020/5620 User Manual

When this programming selection is turned 

On, it allows you to read multiple 

symbols with a single pull of the scanner’s trigger.  If you press and hold the 
trigger, aiming the scanner at a series of symbols, it  reads unique symbols once, 
beeping (if turned on) for each read.  The scanner attempts to find and decode 
new symbols as long as the trigger is pulled.  When this programming selection 
is turned 

Off, the scanner will only read the symbol closest to the aiming beam.

With No Read turned 

On, the scanner sends an “NR” to the host if you pull and 

release the trigger without reading a code (e.g., bad bar code).  If No Read is 
turned 

Off, the “NR” will not be sent to the host.

If you want a different notation than “NR,” for example, “Error,” or “Bad Code,” 
you can edit the output message using the 

code for the No Read symbol is 9C.  

Video Reverse is used to allow the scanner to read bar codes that are inverted.  
The “Off” bar code below is an example of this type of bar code.

Note:  If additional menuing is required, Video Reverse must be disabled to read 

the menu bar codes and then re-enabled after menuing is completed.

Multiple Symbols On

* Multiple Symbols Off

No Read On

* No Read Off

Video Reverse On

* Video Reverse Off