Intel SE7501CW2 User Manual

Intel Server Board SE7501CW2

Installation and Integration Guide 

If your chassis does not have standoffs placed as shown, 
you must rearrange them so they match the holes in the 
server board. Failure to properly rearrange the metal 
standoffs may cause the server board to malfunction and 
permanently damage it. Your chassis may be different from 
the illustration, but you must still arrange the standoffs 
properly. 

When using an Intel Server Chassis SC5200, positions 1, 4, 
6, 20, 23, and 26 come preinstalled. You must install 
standoffs in positions 7, 18, and 19. Install standoffs in the 
eight positions marked P regardless of whether one or 
two processors will be installed. Standoffs are included 
with this chassis.  

  

Attach the rubber bumper to the chassis. The 
bumper should cover the indicated chassis standoff 
hole. On an Intel Server Chassis SC5200, the 
standoff is marked ‘S’. On other chassis, place the 
bumper approximately 3 inches (7.6 cm) below 
and to the left of the standoffs marked P as shown. 

Installing the Server Board  

1.  Place the board into the chassis, 

making sure that the back panel’s 
I/O shield and chassis standoffs align 
correctly.  

 
2.  Attach the board with the included 

screws at the ten locations shown.  

 

If you are installing only one processor, you must also insert screws 
into the four standoff locations around the CPU2 socket. 

 

10