Wacom DTK-2200 User Manual

91

91

USING AN ALTERNATE MOUNT OR STAND

If using Cintiq in an installation that requires the use of an alternate mounting platform, you can mount the 
pen display onto any stand or mounting platform conforming to the VESA MIS-D 100/100 (4 screw) 
standard.

Notes: 

Required mounting screws are 4 mm wide with a 0.7 mm pitch (M4 Regular).  The pen display screw 
holes depth is 12 mm.  Exceeding the clearance depth will damage the internal components of the 
pen display.

Any platform or fixture on which Cintiq is mounted must be able to support the weight of the 
interactive pen display.

To attach the pen display to a VESA mount:

1. Turn off your computer and power off Cintiq.  Then disconnect all cables from between the pen display 

and your computer.

2.

.  Place the pen display face down on a flat, soft surface (such as 

a cloth spread across a desktop).

3. Remove the bearing hub by unscrewing the four bearing hub attachment screws.  Carefully separate 

the bearing halves and remove the bearing stopper to free up the cabling.  Take care not to lose the 
small bearing stopper found within the inner groove of one of the hub sections.  

Cable channel

Rear cover

Bearing stopper

Bearing hub sections 
(removed) and 
attachment screws

•

Remove screws from rear 
cover and lift cover away 
from the pen display.

•

Thread cables through the 
cable channel and reattach 
the rear cover, making sure 
to use the correct screws.  
The rear cover screws are 
shorter than the bearing 
hub screws.