Bunn FMD-5 User Manual

SERVICE (cont.)

FROTHER AND WHIPPER MOTOR (cont.)

6. Pull the frother (6) off the motor shaft. Notice the

flat side on the shaft and the matching flat inside

the frother. It is important that these two flats are

lined up when reassembling.

7. Slip the o-ring (5) off the whipper chamber recep-

tacle (8).

8. Remove nearest side panel and disconnect whipper

motor wires.

9. Remove the two nuts (7) securing whipper chamber

receptacle (8) and whipper motor (10) to the front

panel.

NOTE: To remove the recptacle only, rotate clockwise

until the receptacle clears the nuts (7) and slides

off of the motor shaft.

10. Slide the receptacle with seal off of the motor

shaft.

11. Slide the slinger (9) off of the motor shaft.

12. Remove motor and discard.

13. Install new motor (10) on rear of front panel and

secure with two nuts (7) and connect black leads

on the motor to the main wiring harness. Refer to

Fig. 27 when reconnecting wires

14. Slide slinger (9) onto the motor shaft flush against

the front panel.

15. Wash remaining components in a mild solution of

dish detergent using a bristle brush.

16. Rinse thoroughly and allow to dry before reinstalling

in the dispenser.

17. Slide whipper chamber receptacle with seal (8) and

o-ring (5) on to the motor shaft.

18 Rotate the receptacle with seal (8) counterclockwise

until it snaps into place on the motor mounting nuts

(7).

19. Push frother (6) onto the motor shaft, making sure

the flat in the frother (6) lines up with the flat on

the motor shaft.

20. Install whipper chamber (4) on the whipper chamber

receptacle (8) by twisting counterclockwise until

the tabs on the whipper chamber (4) lock with the

tabs on the whipper chamber receptacle (8). Be

sure dispense port is pointing down.

21. Install dispense tip (3) into the bottom of the whip-

per chamber (4).

22. Slip the mixing chamber (2) onto the mixing chamber

water inlet tube far enough so the mixing chamber

(2) will seat inside the whipper chamber (4).

23. Install the steam collector (1) onto the mixing cham-

ber (2) by pushing down and toward the dispenser

while twisting until the flange on the steam collector

lines up with the slot in the front panel.

24. Install hopper assembly in the dispenser by slid-

ing hopper assembly on the hopper support panel

until the slot in the bottom rear of the hopper seats

against the shoulder screw in the hopper support

panel.

25. Reinstall side panel.

26. Reconnect to power and test.

FIG. 26 WHIPPER MOTOR TERMINALS

P1451.40

BLK to Main Harness

42672 122209