Bunn FMD-5 User Manual

36

J1 Connector for

Three Pin Plug from

Potentiometer

RED from Hopper

Motor

FIG. 28 HOPPER DRIVE BOARD TERMINALS

P1669

BLK from

Hopper Motor

RED/WHI from

Main Harness

WHI from Main

Harness

Removal and Replacement: (Refer to Fig. 27)

1.  Remove hopper assy (17), and set aside for reas-

sembly.

2.  Remove the four #8-32 screws securing the hopper 

support plate (12), remove plate and set aside for 

reassembly.

3.  Remove the four #8-32 screws, located inside the 

dispener housing on the lower right front of the auger 

motor mounting panel (21), securing auger motor 

mounting bracket (18) and auger motor (19) to the 

rear of the auger motor mounting panel (21). 

4.  Disconnect the wires from the terminals on the 

hopper drive board and disconnect the three pin 

plug (J1) from the hopper drive board.

5.  Remove auger motor mounting bracket (18), auger 

motor (19), dust seal (20) and hopper drive board 

as an assembly.

6.  Remove the two #8-32 screws securing the hopper 

drive board to the auger motor mounting bracket.

7.  Remove the two spacers from the hopper drive 

board and discard board.

8.  Install spacers on new hopper drive board.

9.  Install new hopper drive board to the auger motor 

mounting bracket using two #8-32 screws..

10. Refer to Fig. 22 and reconnect the wires to the 

hopper drive board terminals.

11. Connect three pin plug from the potentiometer to 

the hopper drive board J1.  Refer to Fig. 28.

12. Install auger motor mounting bracket with auger 

motor and hopper drive board to the rear of the auger 

motor mounting panel using four #8-32 screws.

13. Install hopper support plate using four #8-32 

screws.

14. Install hopper assy (17).

42672 122209