Crane Merchandising Systems 675 User Manual
Test the Machine
HDC II Programming Guide
6730018
69
July, 2003
WHIP 1 2 3 4 5Whipper motor failure (motor 1, 2, 3, 4, 5).
DOOR JAM
DOOR JAM
The automatic delivery door is jammed.
NO MECH
Coin mech not detected - machine will not operate if config-
ured for coin mech.
ured for coin mech.
MECH COMM
Incomplete coin mech communications — check harness.
MECH.SENSOR
Coin mech reporting a bad tube sensor — replace mech.
MECH ROM
Replace the coin mechanism.
MECH.ERR
There is a problem with the coin mech.
MECH.ACCEPT
Coin mechanism acceptor section is unplugged from the main
body of the coin mech. Connect the cable and cycle machine
power OFF and then ON.
body of the coin mech. Connect the cable and cycle machine
power OFF and then ON.
MECH JAM
One or more coin tubes are jammed. Pay a coin from each
tube until the jam is cleared.
tube until the jam is cleared.
CARD.F.COMM
Incomplete card reader communications (card reader is not
operational).
operational).
DEBIT CARD
Card reader reporting error — machine will not operate if
configured for DEBIT ONLY.
configured for DEBIT ONLY.
CHECK DBV
Bill validator reporting error — machine will not operate.
Empty stacker, clear jams, etc.
Empty stacker, clear jams, etc.
DBV.ACCEPT
The merchandiser is telling the bill validator not to accept any
bills. Check the enabled channels of the bill validator.
bills. Check the enabled channels of the bill validator.
DBV COMM
Incomplete bill validator communications — check harness.
DBV MOTOR
One of the motors has failed. The unit will disable itself until
the error is corrected. Check for bill stuck in the acceptance
path. If no bill is present, replace the validator. Cycle
machine power OFF and then ON.
the error is corrected. Check for bill stuck in the acceptance
path. If no bill is present, replace the validator. Cycle
machine power OFF and then ON.
DBV SENSOR
One of the sensors in the bill validator has failed. The unit
will disable itself until the error is corrected. Check for bill
stuck in the acceptance path. If no bill is present, replace the
validator. Cycle machine power OFF and then ON.
will disable itself until the error is corrected. Check for bill
stuck in the acceptance path. If no bill is present, replace the
validator. Cycle machine power OFF and then ON.
DBV JAM
A bill is jammed in the acceptance path. The unit will disable
itself until the error is corrected. Remove bill stuck in the
acceptance path. Cycle machine power OFF and then ON.
itself until the error is corrected. Remove bill stuck in the
acceptance path. Cycle machine power OFF and then ON.
DBV STACKR
The stacker is open or removed. The unit will disable itself
until the error is corrected. Install the stacker correctly.
until the error is corrected. Install the stacker correctly.
CHK PRICE
Price error detected and changed to maximum - check prices.
NONE READY
all selections are reported out of service.
SV.ERR CUP 1
Cup ring 1 is out of service due to a SureVend™ error.
SV.ERR CUP 2
Cup ring 2 is out of service due to a SureVend™ error.