KitchenAid KUWO24LSBX User Manual
5
2. Drill a
¹⁄₂" (1.27 cm) deep hole in the bottom of the overlay
frame for the bottom hinge pin as shown.
Bottom View
Location Requirements
To ensure proper ventilation for your wine cellar, allow for a
¹/₄"
(6.35 mm) space on each side and at the top. When installing
your wine cellar next to a fixed wall, leave 2
your wine cellar next to a fixed wall, leave 2
¹⁄₂" (6.35 cm)
minimum clearance on the hinge side to allow for the door to
swing open.
swing open.
NOTE: It is recommended that you do not install the wine cellar
near an oven, radiator, or other heat source. Do not install in a
location where the temperature will fall below 55°F (13°C). For
best performance, do not install the wine cellar behind a cabinet
door or block the base grille.
near an oven, radiator, or other heat source. Do not install in a
location where the temperature will fall below 55°F (13°C). For
best performance, do not install the wine cellar behind a cabinet
door or block the base grille.
Electrical Requirements
Before you move your wine cellar into its final location, it is
important to make sure you have the proper electrical
connection.
important to make sure you have the proper electrical
connection.
Recommended grounding method
A 115 Volt, 60 Hz., AC only, 15– or 20–amp fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your wine cellar be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
electrical supply is required. It is recommended that a separate
circuit serving only your wine cellar be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, unplug wine cellar or disconnect power.
removing a light bulb, unplug wine cellar or disconnect power.
Unpack the Wine Cellar
Remove the Packaging
■
Remove tape and glue residue from surfaces before turning
on the wine cellar. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
on the wine cellar. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
■
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your wine cellar. For
more information, see “Wine Cellar Safety.”
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your wine cellar. For
more information, see “Wine Cellar Safety.”
■
Dispose of/recycle all packaging materials.
A. Radius 5.0
¹⁄₂
"
(1.2 cm)
¹⁷⁄₃₂
"
(1.35 mm)
A
Back Surface
Front Surface
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from wine cellar.
gasoline, away from wine cellar.
Failure to do so can result in death, explosion, or fire.
2
¹⁄₂
" (6.35 cm)
¹⁄₄
" (6.35 mm)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
fire, or electrical shock.
WARNING
WARNING
Excessive Weight Hazard
Use two or more people to move and install wine cellar.
Failure to do so can result in back or other injury.
When Moving Your Wine Cellar:
Your wine cellar is heavy. When moving the wine cellar for
cleaning or service, be sure to protect the floor. Always pull
the wine cellar straight out when moving it. Do not wiggle
or “walk” the wine cellar when trying to move it, as floor
damage could occur.
cleaning or service, be sure to protect the floor. Always pull
the wine cellar straight out when moving it. Do not wiggle
or “walk” the wine cellar when trying to move it, as floor
damage could occur.