KitchenAid KUWO24LSBX User Manual

After you remove all of the packaging materials, clean the inside 
of your wine cellar before using it. See the cleaning instructions in 
“Wine Cellar Care.”

IMPORTANT: 

■

Create custom overlay frame according to the specifications 
in the “Custom Overlay Frame” section.

■

KitchenAid is not responsible for the removal or addition of 
molding or decorative panels that would not allow access to 
the appliance for service.

IMPORTANT: Do not remove the grease from the washer, top 
spacer or top hinge pin. Be sure to set aside the top hinge, top 
spacer and washer for later use.

1. Using a Phillips screwdriver, remove the three screws from 

the top hinge. Remove the top hinge.

2. Remove the three screws from the top spacer. Remove the 

top spacer and washer.

3. Open the door. Lift the front of the door up, pulling straight 

out to remove as shown.

NOTE: If the overlay hooks are not installed, see “Custom 
Overlay Frame” for overlay hook locations.

1. Position the overlay frame 

¹⁄₂" (1.27 cm) higher than the door. 

Be sure to position the overlay hooks to the pilot holes. 

2. Insert the overlay hooks into the top of the holes in the door. 

Push against the overlay frame to force the overlay hooks 
deeper into the door. Pull the overlay frame straight down to 
secure the overlay hooks to the door.

3. Using a Phillips screwdriver, attach the overlay plates to the 

bottom of the overlay frame and door as shown.

IMPORTANT: To ensure proper operation, be sure to grease the 
top hinge, top spacer and washer with petroleum jelly.

1. Using a Phillips screwdriver and three screws, attach the top 

spacer to the door.

2. Using petroleum jelly, grease the bottom spacer hole and the 

bottom hinge pin. Align the washer with the bottom spacer 
hole.