Black & Decker SB3040 Instruction Manual

-5-

•  Misuse could cause an injury.

•  Keep loose clothing, hair, jewellery etc. 

away from moving parts.

•  Care is needed when handling cutting 

blades, especially when removing the 

blades and during cleaning.

•  Do not allow children or any person 

unfamiliar with these instructions to use 

the appliance.

•  Do not allow children or animals to come 

near the work area or to touch the 

appliance or power supply cord. Close 

supervision is necessary when the 

appliance is used near children.

•  This appliance is not intended for use by 

persons (including children) with reduced 

physical, sensory or mental capabilities, 

or lack of experience and knowledge, 

unless they have been given supervision 

or instruction concerning use of the 

appliance by a person responsible for 

their safety.

•  Children must be supervised to make 

sure that they do not play with the 

appliance.

•  Switch off the appliance before cleaning, 

changing accessories or approaching 

parts which move in use.

•  Switch off and remove the plug from the 

socket before leaving the appliance 

unattended and before changing, 

cleaning or inspecting any parts of the 

appliance.

•  When not in use, the appliance should be 

stored in a dry place. Children should not 

have access to stored appliances.

•  Before use, check the appliance for 

damaged or defective parts. Check for 

breakage of parts, damage to switches 

and any other conditions that may affect 

its operation.

•  Do not use the appliance if any part is 

damaged or defective.

•  Have any damaged or defective parts 

repaired or replaced by an authorised 

repair agent.

•  Before use, check the power supply cord 

for signs of damage, ageing and wear.

•  Do not use the appliance if the power 

supply cord or mains plug is damaged or 

defective.

•  If the supply cord is damaged, it must be 

replaced by the manufacturer or an 

authorised Black & Decker Service 

Centre in order to avoid a hazard.

•  Never attempt to remove or replace any 

parts other than those specified in this 

manual.

This tool is double insulated in 

accordance with EN 60335; 

therefore no earth wire is required.

Always check that the power supply 

corresponds to the voltage on the rating 

plate.

To avoid the risk of electric shock, 

do not immerse the cord, plug or 

motor unit in water or other liquid.