Mitsubishi Electronics 882.00273.00 User Manual
7-4 Addendum (Service Supervisor Information)
Note: This section of the manual should not be used by untrained personnel –
blender controller and/or program can be compromised!
Note: Hidden, programmable features and hidden menu pages should not be
made available to floor operators. These pages include the Service
Supervisor Information addendum located in this section. Unauthorized
changes to these factory settings by inexperienced operators may
prevent the unit from operating properly, and may void part or all of the
warranty.
Supervisor Information addendum located in this section. Unauthorized
changes to these factory settings by inexperienced operators may
prevent the unit from operating properly, and may void part or all of the
warranty.
Caution!
After all selections are made: Keep pressing the “Done” key until the unit
returns to the Recipe menu.
returns to the Recipe menu.
Note: Programmable features should not be accessed by inexperienced
operators or inexperienced plant personnel. Unauthorized changes may
prevent the blender from operating properly and may void part or all of
the warranty.
prevent the blender from operating properly and may void part or all of
the warranty.
Note: Call the Service Department for assistance or for further explanation of
these or any other programmable features, which may or may not be
shown in this manual.
shown in this manual.
Note: Information included in this manual is subject to change without notice.
Passwords
• User Password
“5413”
• Maintenance Password
“3145348”
Caution!
Maintenance password should only be supplied to qualified personnel!
The program can be compromised.
The program can be compromised.
Programmable Settings
The Slide Gate/Auger blender software program has been designed to allow some
customizing to achieve certain desired operating parameters. The following is a listing of the
selections that are “field” programmable, followed by the procedure for doing so.
customizing to achieve certain desired operating parameters. The following is a listing of the
selections that are “field” programmable, followed by the procedure for doing so.
This menu is accessed by pressing the manufacturer’s icon when in the “Setup” Directory
Screen menu.
Screen menu.
Figure 65: Typical Operator Setup Screen
Touch this icon and
enter in the Service
Password to access the
Engineering Only
Directory
enter in the Service
Password to access the
Engineering Only
Directory
Enter the long password “3145348” and press “Enter”. The factory setup section displays the
“Engineering only” screen. The screen similar to that shown below should be displayed and
use the keystrokes described herein to change or toggle the parameters.
“Engineering only” screen. The screen similar to that shown below should be displayed and
use the keystrokes described herein to change or toggle the parameters.
BF1-615.3
Chapter 7: 6BAppendix
86 of 101