Bunn ITB User Manual

Page 29

A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems 

encountered.  If  the  problem  remains  after  exhausting  the  troubleshooting  steps,  contact  the  Bunn-O-Matic 

Technical Service Department.

•  Inspection, testing, and repair of electrical equipment should be performed only by qualified service person-

nel.

•  All electronic components have 120-240 volt ac and low voltage dc potential on their terminals. Shorting of

terminals or the application of external voltages may result in board failure.

•  Intermittent operation of electronic circuit boards is unlikely. Board failure will normally be permanent. If

an intermittent condition is encountered, the cause will likely be a switch contact or a loose connection at a 

terminal or crimp.

•  Solenoid removal requires interrupting the water supply to the valve. Damage may result if solenoids are

energized for more than ten minutes without a supply of water.

•  The use of two wrenches is recommended whenever plumbing fittings are tightened or loosened. This will

help to avoid twists and kinks in the tubing.

•  Make certain that all plumbing connections are sealed and electrical connections tight and isolated.

•  This brewer is heated at all times. Keep away from combustibles.

41581.2 091609