Smeg ALFA135BE User Manual
Instructions for the User
28
4.9 Rapid cooling
The oven has a special function which allows its interior to be cooled
quickly. To activate this function, turn the function selector to "0", open the
door and press the START key for at least 2 seconds. The fans inside the
oven will come into operation with the heating elements off. To stop the
function, press the STOP key.
quickly. To activate this function, turn the function selector to "0", open the
door and press the START key for at least 2 seconds. The fans inside the
oven will come into operation with the heating elements off. To stop the
function, press the STOP key.
4.10 Key to the oven's beep sounds
All the beep sounds the oven emits are different from each other, in order
to allow the user to identify exactly what the oven is doing.
Parameter setting/modification menu = 1 single beep
End of preheating and pause before start of cooking = 5 beeps followed by
a pause of 2 seconds.
Start of cooking = 2 single beeps.
Door open during preheating and cooking = continuous beep.
End of cooking = 3 beeps followed by pause of 4 seconds.
to allow the user to identify exactly what the oven is doing.
Parameter setting/modification menu = 1 single beep
End of preheating and pause before start of cooking = 5 beeps followed by
a pause of 2 seconds.
Start of cooking = 2 single beeps.
Door open during preheating and cooking = continuous beep.
End of cooking = 3 beeps followed by pause of 4 seconds.
4.11 Possible error messages on the display
4.11.1
Err1
This message appears whenever the software detects that the sensor
connector is not properly connected to the electronic circuit board or has
short-circuited.
connector is not properly connected to the electronic circuit board or has
short-circuited.
This error resets automatically when the oven’s power supply is switched
off. If the error persists, call the After-Sales Service.
4.12 Technical notes
If the power supply to the appliance fails at any time, always return the
knob to the 0 setting before running any programs.
knob to the 0 setting before running any programs.