Cornelius 3 User Manual
Viper Service Manual
© 2010, IMI Cornelius Inc.
- 23 -
Publication Number: 621360041TBSER
When the sleep and wakeup settings and the defrost lockout settings are
complete, press the BACK button to save the settings and return to the Select
menu, shown in Figure 13.
complete, press the BACK button to save the settings and return to the Select
menu, shown in Figure 13.
Setting Events
Events setup allows the user to set sleep periods for the unit and to lock out the
defrost cycle during peak busy times. Sleep periods and defrost lockouts may be
programmed for individual days of the week or for all days of the week,
depending on location requirements.
defrost cycle during peak busy times. Sleep periods and defrost lockouts may be
programmed for individual days of the week or for all days of the week,
depending on location requirements.
Setting the Sleep and
Wakeup Times
Wakeup Times
Sleep and wakeup times are set on the Event Setup menu shown in Figure 16.
To set the sleep and wakeup times, perform the procedure in Table 16.
To set the sleep and wakeup times, perform the procedure in Table 16.
When the unit goes into a sleep period, the barrel automatically defrosts for four
minutes. Also, if a barrel is off when the sleep cycle starts, the barrel continues
to be in the off state when the sleep cycle ends. If a barrel is running when the
sleep cycle starts, the barrel starts back up when the sleep cycle ends.
minutes. Also, if a barrel is off when the sleep cycle starts, the barrel continues
to be in the off state when the sleep cycle ends. If a barrel is running when the
sleep cycle starts, the barrel starts back up when the sleep cycle ends.
Wakeup should be scheduled for approximately one hour before product is required.
NOTE: Setting the sleep time after midnight requires you to set it dur-
ing the next day. (i.e. Saturday night at 1am must be set as 1am on
Sunday, etc.) If this type of setting is required, you cannot set another
sleep cycle during that following day, i.e. Sunday.
ing the next day. (i.e. Saturday night at 1am must be set as 1am on
Sunday, etc.) If this type of setting is required, you cannot set another
sleep cycle during that following day, i.e. Sunday.
Table 15
Button
Description
BACK
Returns the display to the Select menu and saves current settings
CLEAR
Clears the highlighted field on the menu
-
Decrements the highlighted field
+
Increments the highlighted field
Table 16
Step
Action
Procedure
1
Set sleep and wakeup
times
Open the Events Setup menu, shown in Figure 16
by pressing the GO button.
2
Select DAY
The DAY field is highlighted.
3
Set DAY
Use the + or - buttons at the bottom of the display
to set the desired day or all days.
4
Select SLEEP
Use the up and down arrows to highlight SLEEP.
5
Set hour field
Use the left and right arrows to select the hour field
and press the + or - buttons to change the hour.
6
Set minute field
Use the left and right arrows to select the minute
field and press the + or - buttons to change the
minutes (15 min. increments)
7
Select AM/PM field
If the 12 hour clock option is selected, use the left and
right arrows to select the AM/PM field. Then press
the + or - buttons to change between AM and PM.
8
Select DAY for Wakeup
Repeat Steps 2 and 3 as needed.