Cornelius 3 User Manual

                               

Viper Service Manual

© 2010, IMI Cornelius Inc.

- 25 -

Publication Number: 621360041TBSER

17, allows the user to adjust the viscosity in each barrel to the optimum setting 
for each type of syrup.

Refer to the Installation manual for the recommended settings based on syrup type.

To set all barrels in the system to the same viscosity setting, perform Steps 1 
through 4 in Table 18 and then press the ALL button at the bottom of the display 
while highlighting the viscosity setting you desire for all the barrels. When the 
viscosity settings are complete, press the BACK button to save the settings and 
return to the Select menu, shown in Figure 13.

The CO

2

 Setup menu, shown in Figure 18, allows the user to adjust the percentage of 

time that the CO

2

 pulse valves are open. This provides an adjustment of the overrun 

for the unit when using different syrups. The valves use a one second interval dura-
tion time. Setting a valve to 45 activates the valve for 450 msec. out of each second.

The CO

2

 pulse valves may be set between 0 and 100%, in 5% increments. To 

change the settings of the CO

2

 pulse valves, perform the procedure in Table 19.

1

Set viscosity range

From the Setup screen (Figure 13), open the Viscos-

ity Setup screen, shown in Figure 17.

2

Select barrel

Use the Up and Down arrows to highlight the desired 

barrel.

3

Select range field

Use Left and Right arrows to select range field

4.

Set range

Use the + or - buttons at the bottom of the display to 

set the desired range.

5

Select barrel

Repeat Steps 2 through 4 for all barrels.

VISC

SETUP

12:51P

MAR 04

#1 VISC RANGE    6  48-110

#2 VISC RANGE    6  48-110

BACK                  ALL          -            +

BACK  

             

     ALL         -           +

CO2

SETUP

12:51P

MAR 04

#1 CO2 PULSE %:  45

#2 CO2 PULSE %   45

#3 CO2 PULSE %   45