Cornelius 3 User Manual

Viper Service Manual                                   

Publication Number: 621360041TBSER

- 48 -

© 2010, IMI Cornelius Inc.

Flush the wash water from the system by performing the procedure in Table 41.

1. 

Use a clean 5-gallon pall filled with a sanitizing solution and water at a temper-

ature of 90º F to 110º F (32º C to 43º C). The sanitizing solution must have 

200-ppm available chlorine.

2. 

Connect a sanitizing fitting (p/n cc 28688) to the BIB connector. Put the con-

nector in the bucket of sanitizing solution.

3. 

Make sure the 

Product/BRIX valve in the BRIX position.

4. 

Hold waste container under the BRIX tube to collect flush water from the syrup 

line and open the manual syrup flow valve to start filling the syrup line with 

sanitizing solution. Continue to hold the syrup flow valve open until sanitizing 

solution starts coming out of the BRIX tube.

5. Turn 

the 

Product/BRIX valve in the Product position.

6. 

Manually override (open) the syrup flow valve to fill the barrel with sanitizing 

solution.

7. 

Fill the barrel with sanitizing solution by opening the faceplate relief valve until 

sanitizing solution comes out of the relief port.

8. 

Hold a 16 oz. cup under the dispense valve. Hold the dispense valve fully 

open until the cup is full.

9. 

Use the brush provided with the unit to clean the relief port and clean the out-

let of the dispense valve with sanitizing solution.

10. From 

the 

Barrel Status menu, press the SPIN button while highlighting the 

appropriate barrel. This starts the scraper blade. Allow blade to operate for 

minimum of 10, but no more than 15 minutes. Turn the scraper blade off by 

pressing the 

OFF button.

11. 

Place a large container under the dispense valve and drain as much sanitizing 

solution as possible from the barrel.

12. 

When the pressure in the barrel drops, from the 

Barrel Maintenance menu, 

press the 

PURGE button to re-pressurize the barrel with CO

2

. As sanitizing 

solution level lowers in the barrel, partially close the valve to avoid spurting.

1. 

Turn the Product/BRIX valve to the Product position.

2. 

Manually open the manual water flow valve to start filling the barrel with wash 

water. At the same time, open the faceplate relief valve until water comes out.

3. 

From the Barrel Status menu, press the SPIN button while highlighting the 

appropriate barrel. This starts the scraper blade. Allow the blade to operate for 

fifteen seconds, then turn barrel OFF by pressing the OFF button.

4. 

To drain the water from the system, turn the barrel OFF.

5. 

Place a container under the barrel dispensing valve. Open the dispensing 

valve and dispense all rinse water from the barrel. When the pressure in the 

barrel drops, from the Barrel Maintenance menu, press the PURGE button to 

re-pressurize the barrel with CO

2

. As the wash water level lowers in the barrel, 

partially close the valve to avoid spurting.

6. 

Remove the sanitizing fitting (p/n cc 28688) from the BIB connector and con-

nect a BIB containing syrup to the syrup line.