Whirlpool W10400322F Manual

For non-vented (recirculating) installations:

The charcoal filter is not washable. It should last up to 6 months
with normal use.

1. Replace metal grease filter with a charcoal filter. For

information on ordering, see the “Accessories” section.

To replace filter:

1. Remove screw from the grease filter retainer.

2. Turn the grease filter retainer to release filter.

3. Reinstall the filter by placing the back edge in the channel at

rear of hood. Push filter into place, turn the filter retainer to
secure filter to range hood.

4. Replace screw in the grease filter retainer.

Replacing the Incandescent Light Bulb

Turn off the range hood and allow the light bulb to cool.

1. Disconnect power.

2. Squeeze the plastic lens cover and remove it from the hood.

3. Screw light bulb into socket.

4. Replace lens cover by squeezing cover and inserting tabs

into slots.

5. Reconnect power.

If new light does not operate, make sure the lamp is inserted
correctly before calling service.

WIRING DIAGRAM

A. Light bulb socket
B. Lens cover

C25

SE114A

1.2 ±10% A

73 ±10% Watts

17.1 ±10% Ohms

13.6 ±10% Ohms

Motor Characteristics

Power Supply

120 VAC

Frequency

60 Hz

Amperage

Wattage Rating

Motor Resistance

White - Red

White - Black

Lamp Switch
Off - Low - High

Motor Switch
Off - On

Lamp Switch
Operation

1 - 3

Low

1 - 2

Off

1 - L High

Ground
Screw

GND

Speed 2

Common

Speed 1

NOTE: Speed 1
not used

Rectifier
Diode