Liebherr 200514 User Manual

u

In  the  case  of  an  appliance  with

enclosed wall spacers, mount the

wall  spacers  on  the  back  of  the

appliance at the top left and right.

u

u

Align  the  appliance  so  that  it

stands firmly and on a level by

applying  the  accompanying

spanner  to  the  adjustable-

height  feet  (A)  and  using  a

spirit level.

u

Then support the door: Extend

the adjustable foot at the turn

hinge  (B)  until  it  rests  on  the

floor  and  then  make  a  further

90° turn.

u

Clean the appliance (see 6.2) .

If  the  appliance  is  installed  in  a  very  damp  environment,

condensate may form on the outside of the appliance.

u

Always see to good ventilation at the installation site.

You can change over the door hinges if necessary.
Ensure that the following tools are to hand:

q

Torx® 25

q

Torx® 15

q

Screwdriver

q

Cordless screwdriver, if necessary

q

Second person for fitting work, if needed

u

Remove any food from the door racks before removing the

door, so that no food falls out.

Fig. 4 

u

Close the upper door.

u

Pull off the cover

 Fig. 4 (1)

 forwards and upwards.

u

Lift off the cover

 Fig. 4 (2)

.

Risk of injury if the door tips!

u

Take good hold of the door.

u

Set down the door carefully.

u

Unscrew  the  upper  turn  hinge

  Fig.  4  (3)

(2x  Torx®  25)

Fig. 4 (4)

 and lift it off.

u

Lift up the upper door and set it aside.

u

Close the lower door.

u

Draw the middle bearing pin

 Fig. 5 (11)

 out of the turn hinge

and lower door.

u

Remove the plastic cap

 Fig. 5 (10)

.

Risk of injury if the door tips!

u

Take good hold of the door.

u

Set down the door carefully.

u

Open the lower door.

u

Unscrew the middle turn hinge (2x Torx® 25).

 Fig. 5 (13)

u

Lift up the door and set it aside.

Fig. 5 

u

Carefully detach the cover panel

 Fig. 5 (12)

.

u

Turn  the  middle  turn  hinge

  Fig.  5  (13)

  with  the  washer

Fig. 5 (14)

 through 180° and screw it firmly into place on the

new hinge side (with 4 Nm).

u

Turn  the  cover  panel

  Fig.  5  (12)

  through  180°  and  snap  it

into place again on the new handle side.