Lucent Technologies 5 User Manual
MERLIN LEGEND Communications System Release 5.0
System Manager’s Guide
System Manager’s Guide
555-650-118
Issue 1
June 1997
Managing the System
Page 6-92
Removing a CTI Link
6
o
Follow the procedure in the preceding topic,
, to restore service on the module where the CTI link is
located.
o
When you have finished, file Form 2a with the rest of the planning forms.
o
To install the server-related hardware associated with the link, contact your
Lucent Technologies representative.
Lucent Technologies representative.
Programming Instructions
6
Removing a CTI Link
6
Use this procedure to remove the programming for a CTI (Computer Telephony
Integration) link from an MLX port on a 008 or 408 MLX module. This
hardware/software feature is available in Release 5.0 and later systems operating
in Hybrid/PBX mode.
Integration) link from an MLX port on a 008 or 408 MLX module. This
hardware/software feature is available in Release 5.0 and later systems operating
in Hybrid/PBX mode.
NOTE:
This topic describes only the last steps in adding a CTI link to the system.
Additional LAN-related procedures are described in the
Additional LAN-related procedures are described in the
PassageWay
Telephony Services Network Manager’s Guide.
Task List: Removing a CTI Link
6
o
Obtain Form 2a, System Numbering: Extension Jacks.
o
Record the new values on Form 2a.
o
If necessary, read “Auxiliary Equipment” in
System Programming
, Chapter
4, for additional information.
o
Open the System Programming menu from the console or a PC with SPM.
o
Follow the procedure outlined in
to terminate service on the module where the CTI
link is located.
o
Program the change(s), following the appropriate instructions for “Auxiliary
Equipment” in
Equipment” in
System Programming
, Chapter 4, or the appropriate
summary programming instructions below.
o
Follow the procedure outlined in
was located.
Console Procedure
AuxEquip
→
CTI Link
→
Extension
→
Dial ext. no.
→
Enter
→
Exit
→
Exit
PC Procedure
→
→
→
Type ext. no.
→
→
→