Broilmaster SBG2500-1 User Manual
SBB00101-1-1007
Page 14
PROPANE GAS GRILLS (cont.)
Installation must conform to local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1. In Canada,
installation shall be in accordance with CAN/CGA-B149.2 Propane
Installation Code, or CAN/CGA-B149.1 Natural Gas Installation
Code, and local codes where applicable. Consult your local gas
supplier or propane gas dealer for code regulations and recom-
mended procedures.
Warning: Superb by Broilmaster
Warning: Superb by Broilmaster
®
Gas Grills require Liquid
Propane (LP) cylinders equipped with an Overfill Protection
Device (OPD). An overfilled or improperly filled Propane cyl-
inder can be dangerous.
Always use the pressure regulator and hose assembly supplied with
Always use the pressure regulator and hose assembly supplied with
your Propane gas grill.
Note: Not all valve and cylinder combinations are compatible.
Note: Not all valve and cylinder combinations are compatible.
Check warning tag on valve and cylinder as well as external fit-
ting threads.
All Broilmaster pressure regulators and hose assemblies require
All Broilmaster pressure regulators and hose assemblies require
Propane cylinders with a Type 1 connection device as illustrated.
See Figure 16.
Pressure Regulator and Hose Assembly
The pressure regulator has an outlet pressure of not more than
The pressure regulator has an outlet pressure of not more than
eleven (11”) inches water column. It must be connected to the
Propane gas cylinder’s female valve outlet before the grill can be
operated.
Caution: Operation of a propane gas grill without the pres-
Caution: Operation of a propane gas grill without the pres-
sure regulator and hose assembly will cause gas leaks which
could lead to fire or explosion, resulting in property damage
or personal injury.
The pressure regulator’s fitting must remain clean and free of
The pressure regulator’s fitting must remain clean and free of
nicks and scratches. A dirty, nicked or scratched fitting can cause
a gas leak, resulting in an explosion or fire. Use only genuine
Broilmaster
®
replacement parts unless otherwise specified by the
manufacturer.
Connecting to Propane Gas / Cylinder Retention Means
Attention: Propane gas cylinders that are acceptable for use with
Connecting to Propane Gas / Cylinder Retention Means
Attention: Propane gas cylinders that are acceptable for use with
this grill must comply with “Cylinder Requirements” section and
“Connection Requirements” section (Pages 13-14.)
Lift up the tank ring. Position the cylinder in the opening at the
Lift up the tank ring. Position the cylinder in the opening at the
bottom of the cart then fit the tank ring out side of the tank. See
Figure 15.
Figure 15
Attach the pressure regulator to the Propane gas cylinder’s valve
using the plastic handwheel. Tighten in a clockwise motion to
achieve a gas tight seal. See Figure 16.
Figure 16
Caution: Do not use a wrench or any other tool to tighten. Use
of a wrench or other tool will damage the plastic handwheel.
Fit hose to the hook inside of the right side panel. See Figure 17.
Figure 17
To disconnect the Propane gas cylinder, turn OFF the cylinder’s
valve and the grill’s control valve. Remove the regulator by turning
the plastic handwheel counterclockwise.
Clockwise