Empire Comfort Systems FD42FB2DF-1 User Manual

Page of 20
Page 3
23200-0-1206
The installation must conform with local codes or, in 
the absence of local codes, with the National Fuel Gas 
Code, ANSI Z223.1 (latest edition) and to the National 
electrical Code, ANSI/NFPA70 (latest edition).
NOTE: Installation and repair should be done by a quali-
fied service person. The appliance should be inspected 
before use and at least annually by a qualified service 
person. More frequent cleaning may be required due to 
excessive lint from carpeting, bedding material, etc. It 
is imperative that control compartment, burners and 
circulating air passageways of the appliance be kept 
clean.
Any safety screen or guard removed for servicing an 
appliance must be replaced prior to operating the ap-
pliance. Provide adequate combustion and ventilation 
air.
The flow of combustion and ventilation air MUST NOT 
be obstructed.
Provide adequate clearance around air openings into 
the  combustion  chamber  and  adequate  accessibility 
clearance for servicing and proper operation. NEVER 
obstruct the front opening of the appliance.
This  Empire  Comfort  Systems,  Inc.  firebox  and  its 
components have been tested and will operate safely when 
installed in accordance with this installation manual. 
Read all instructions before starting installation, then 
follow these instructions carefully during installation 
to maximize firebox benefit and safety. Report to your 
dealer any parts damaged in shipment.
The Empire Comfort Systems, Inc. warranty will be 
voided by, and Empire Comfort Systems, Inc. disclaims 
any responsibility for the following actions:
-  Installation of any damaged firebox.
-  Modification of the firebox or any of the components 
parts thereof.
-  Installation  other  than  as  instructed  by  Empire 
Comfort Systems, Inc.
-  Installation and/or use of any component part or 
accessory not approved by Empire Comfort Systems, 
Inc.  in  combination  or  assembly  with  a  Empire 
Comfort Systems, Inc. firebox, not withstanding any 
independent testing laboratory or other third party 
approval of such component part or accessory.
Any such action may create a possible fire hazard.
Consult your local building codes.
Firebox Screen.
The firebox screen must be in place when the firebox is 
operating.
Instructions to Installer
1.  Installer  must  leave  instruction  manual  with  owner  after 
installation.
2.  Installer must have owner fill out and mail warranty card 
supplied with firebox.
3.  Installer should show owner how to start and operate log set 
that is installed into firebox.
Important
All  correspondence  should  refer  to  complete  Model  Number, 
Serial Number.
Notice: During initial firing of this firebox with a log set installed, its 
paint will bake out, and smoke will occur. To prevent triggering of 
smoke alarms, ventilate the room in which the unit is installed.
Qualified Installing Agency
Installation  and  replacement  of  gas  piping,  gas  utilization 
equipment or accessories and repair and servicing of equipment 
shall be performed only by a qualified agency. The term "qualified 
agency"  means  any  individual,  firm,  corporation  or  company 
which either in person or through a representative is engaged in 
and is responsible for (a) the installation or replacement of gas 
piping or (b) the connection, installation, repair or servicing of 
equipment, who is experienced in such work, familiar with all 
precautions required and has complied with all the requirements 
of the authority having jurisdiction.
State  of  Massachusetts:  The  installation  must  be  made  by 
a  licensed  plumber  or  gas  fitter  in  the  Commonwealth  of 
Massachusetts.  The  state  of  Massachusetts  requires  that  a 
flexible  appliance  connector  cannot  exceed  three  feet  in 
length.
Sellers of unvented propane or natural gas-fired supplemental 
room heaters shall provide to each purchaser a copy of 527 
CMR 30 upon sale of the unit.
In the State of Massachusetts, unvented propane and natural 
gas-fired space heaters shall be prohibited in bedrooms and 
bathrooms.
The installation must conform with local codes or, in the absence 
of local codes, with the National Fuel Gas Code, ANSI Z223.1/
NFPA 54.*
*Available from the American National Standards Institute, Inc., 11 West 
42nd St., New York, N.Y. 10036.
IMPORTANT SAFETY INFORMATION
INTRODUCTION