Manualsbrain.com
  1. Manuals
  2. Brands
  3. Philips
  4. CMD305A/05
  5. User Manual

Philips CMD305A/05 User Manual

Download
Page of 30
6
EN
3  Before use
Caution
 
•
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in 
sequence.
If you contact Philips, you will be asked for the 
model number and serial number of your car 
audio system. The model number and serial 
number are on its bottom. Write the numbers 
here:
Model No.: __________________________
Serial No.: ___________________________
Install the car audio system
These instructions are for a typical installation. 
However, if your car has different requirements, 
make the adjustment accordingly. If you have 
any question regarding installation kits, consult 
your local retailer.
Caution
 
•
This system is designed for negative ground (earth) 12V 
DC operation only.
 
•
Always install this system in the car dashboard. Other 
locations can be dangerous as the rear of the system heats 
up during use.
 
•
To avoid short-circuit: before you connect, make sure that 
the ignition is off.
 
•
Make sure that you connect the yellow and red power 
supply leads after all other leads are connected.
 
•
Make sure that all loose leads are insulated with electrical 
tape.
 
•
Make sure that the leads do not get caught under screws 
iron parts that will move (e.g. seat rail).
 
•
Make sure that all ground (earth) leads are run to a 
common ground (earth) point.
 
•
Use only the supplied mounting hardware for a safe and 
secure installation.
 
•
Improper fuses can cause damage or fire. When you need
to change the fuse, consult a professional.
 
•
When you connect other devices to this system, make 
sure that the rating of the car circuit is higher than the 
total fuse value of all the connected devices.
 
•
Never connect speaker wires to the metal body or chassis 
of the car.
 
•
Never connect speaker wires with stripes to one another.
Connect wires
Caution
 
•
Make sure that all loose leads are insulated with 
electrical tape.
1 
Check the car's wiring carefully, and then 
connect them to the supplied ISO wires.
 
  Connector Connect to
1 Yellow wire The +12V car battery which is 
live at all times
2 Blue/White 
wire
The electric antenna control 
lead or power supply lead of 
the antenna booster. If there is 
no electric antenna or antenna 
booster, or it is manually 
operated telescopic antenna, it 
is unnecessary to connect this 
lead.
3 Black wire A metal surface of the car. 
Connect the black ground 
(earth) lead before connecting 
the yellow and red power 
supply leads.
a
b
c
d
e
f
g
h