Philips CMD305A/05 User Manual
7
EN
Connector Connect to
4 Red wire
The +12V power terminal
which is live in the accessory
(ACC) position of the ignition
switch. If there is no accessory
position, connect to the +12V
car battery terminal that is
always live. Make sure that the
black ground (earth) lead is
connected to a metal surface of
the car first.
5 Green and
green/black
wires
Left speaker (rear)
6 White and
white/black
wires
Left speaker (front)
7 Gray and
gray/black
wires
Right speaker (front)
8 Purple and
purple/black
wires
Right speaker (rear)
2
Connect the other end of the supplied
standard connector to the car audio
system.
a
b
b
c
d
e
f
g
h
SUB-W
REAR LINE OUT
L
R
Connector
Connect to
1 ANTENNA
Antenna for radio
2 External Mic
An external
microphone for
phone call
3 SUBWOOFER
(Socket)
Subwoofer
4 REAR LINE OUT L
(Socket)
Rear left speaker
5 REAR LINE OUT R
(Socket)
Rear right speaker
6 OE REMOTE
(Brown)
OE remote
7 FRONT LINE OUT L Front left speaker
8 FRONT LINE OUT
8 FRONT LINE OUT
R
Front right speaker
Tip
•
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Be sure to make
proper connections to prevent damage to the system.
Mount into the dashboard
Note
•
If your car has no an on-board drive or navigation
computer, disconnect the negative terminal of the car
battery.
•
If your car has an on-board drive or navigation
computer, the computer may lose its memory when
you disconnect the car battery.
•
If the car battery is not disconnected, to avoid short-
circuit, make sure that bare wires do not touch each
other.