Lexmark C935 Quick Setup Guide

The printer has a standard 520-sheet tray (Tray 1), and it may have

one or more optional 520-sheet trays. All 520-sheet trays support

the same paper sizes and types. Paper may be loaded in the trays

in either the long-edge or short-edge orientation.

Grasp the handle, and pull the tray out.

Squeeze the width guide tabs together as shown, and move

the width guide to the correct position for the paper size being

loaded.

Squeeze the length guide tab inward as shown, and slide the

guide to the correct position for the paper size being loaded.

Note: Use the size indicators on the bottom of the tray to help

position the guides.

Flex the sheets back and forth to loosen them, and then fan

them. Do not fold or crease the paper. Straighten the edges on

a level surface.

Load the paper stack with the recommended print side faceup.

Load the paper in either the long-edge or short-edge

orientation as shown below:
Notes:

Load sizes larger than A4 in the short-edge orientation.

Paper must be loaded in the short-edge orientation to

create booklets if the optional booklet finisher is installed.

Make sure the paper guides are secure against the edges of

the paper.

Align the tray, and insert it.

If a different type of paper was loaded than the type previously

loaded in the tray, change the Paper Type setting for the tray

from the control panel.