Adtran express 3000 User Guide

Chapter 2.  Setting Up the Express 3000

2-2

Express 3000 User Manual

61203153L2-20

The following Step/Action tables provide step-by-step instructions 
for installing the Express 3000. However, the basic installation proce-
dure is as follows:

1.

Connect and power up the hardware (see page 2-2).

2.

Install the Express 3000 into the operating system (see page 2-3).

3.

Install the Express Configuration software (see page 2-4).

As the first step in getting your Express 3000 up and running, install 
the hardware. To ensure success, closely follow the instructions be-
low—particularly those relating to installing the cables.

With the computer’s power off and using an appropriate serial 
cable (this serial cable is not provided—see Table 1-1 on 
page 1-3), connect the EIA-232 port on the Express 3000 to 
an available COM port on the computer.

Plug the Express 3000 power supply cord into the port on the 
unit labeled 

PWR. Plug the other end into an electrical outlet. 

The Express 3000 is now powered on.

Plug the large (RJ-45) end of the provided ISDN cable into the 
jack on the rear of the Express 3000 labeled 

ISDN; plug the 

small (RJ-11) end of the same ISDN cable into the ISDN 
telephone wall jack.