Mitsubishi lt-3280 Owner's Manual

Note: If you selected “Other” for any of the device 
names, the media center can “Learn” the connected 
device by following the Edit NetCommand instructions.   
For many device types, non-listed models will operate in 
the same way as the listed models and you can still use 
the pre-loaded setting.

The TV Guide On Screen option allows you to select 

whether you want to enable the Guide and which devices 
you want to include in the listing.  In order to get the 
correct listings for your area, you will need to enter your 
5-digit ZIP code.  

Depending on your setup, you can select either or both 
antenna inputs, or antenna inputs and a cable box, or 
Cable CARD™ on Antenna 1 and an over-the-air antenna 
on Antenna 2.  If you have multiple cable connections 
such as direct cable without a box on one antenna and 
a cable box on the other antenna or an input, these will 
share the same channel number assignment and as a 
result may not match correctly for both connections.

For detailed information on using the TV Guide On 
Screen system, please see the TV Guide On Screen® 
Interactive Program Guide User’s Manual. 

After you have made your device choices the Review Screen 

will display.  It is important to review the settings to ensure 
that they are correct.  If necessary, you can use <Back to 
return to the Device Setup screen to make changes.  

Note:  The Review screen lists the media center input 
and A/V receiver input used with each device.  You 
must correctly identify the inputs you used when you 
connected the devices.  If you have not connected 
your devices, write down these inputs as a guide.  If 
you cannot use these inputs, or if you would like to 
change the name of a device, use the instructions in Edit 
NetCommand to make necessary changes.

Note: If you select Next> on the Review screen, all 
selections made are finalized.

On the Review screen, adding or deleting check marks will 
turn the adjacent devices, memory cards or inputs On or 
Off.  1394 device names only appear on the Review screen 
when the devices are connected to the media center.

To complete the NetCommand setup, select Finish from 
the Finish screen. 

If you wish to change any of the pre-configured inputs 
or names for the devices, or add devices not in the 
pre-configured setup, select Edit to display Edit 
NetCommand menu.

If your A/V receiver (AVR) was not listed, select Edit to 
add the AVR and then assign all devices to new AVR 
inputs.  

Note:  Inputs to TV Guide On Screen can include only one 
over-the-air source and one cable souce.

If you connect an HDTV cable box to the TV using Com-
ponent 1 or 2, HDMI Input 1 or 2, or IEEE 1394, and plan 
to use TV Guide On Screen to control this cable box, also 
connect an over-the-air antenna in order to download TV 
Guide On Screen data.