ASKProxima c130 User Manual
44
Appendix
Projected Image Size
NOTE
: Visit our website for an interactive image size calculator.
Red LED Behavior and Projector Errors
If the projector is not functioning properly and the LED is blinking red, con-
sult Table 3 to determine a possible cause. There are two-second pauses
between the blinking cycles. Visit our website for more details on the red
LED error codes.
sult Table 3 to determine a possible cause. There are two-second pauses
between the blinking cycles. Visit our website for more details on the red
LED error codes.
Table 2:
Range of distance to the screen for a given screen size for the
projector
Diagonal
Screen Size
(inches/m)
Screen Size
(inches/m)
Distance to screen
Image Width
(inches/m)
(inches/m)
Maximum
distance
(feet/m)
distance
(feet/m)
Minimum
Distance
(feet/m)
Distance
(feet/m)
50/1.3
40/1
7.8/2.4
6,5/2.0
60/1.5
48/1.2
8.8/2.7
7.5/2.3
100/2.5
80/2
14.6/4.5
12.4/3.8
150/3.8
120/3.1
22.6/6.9
19.03/5.8
200/5.1
160/4.1
30.5/9.3
25.2/7.7
Table 3: LEDs
Red LED Behavior
Explanation
One (1) blink
The lamp won't strike after five (5)
attempts. Check the lamp and lamp door
installations for loose connections.
attempts. Check the lamp and lamp door
installations for loose connections.
Three (3) blinks
The projector has shut down. Check to
see if the lamp door is open. If the lamp
door is closed, toggle off the projector
and wait one minute, then toggle the pro-
jector on again. If the lamp does not strike
after one minute, replace the lamp. Con-
tact Technical Support (see page 28) for
repair if replacing the lamp does not solve
the problem.
see if the lamp door is open. If the lamp
door is closed, toggle off the projector
and wait one minute, then toggle the pro-
jector on again. If the lamp does not strike
after one minute, replace the lamp. Con-
tact Technical Support (see page 28) for
repair if replacing the lamp does not solve
the problem.
Four (4) blinks
The fan has failed. Contact Technical Sup-
port (see page 28) for repair.
port (see page 28) for repair.
Five (5) blinks
The projector is overheating. Check for a
blocked air vent or clogged lamp housing
screen (previous page). Contact Technical
Support for repair if clearing the vents/
screens does not solve the problem.
blocked air vent or clogged lamp housing
screen (previous page). Contact Technical
Support for repair if clearing the vents/
screens does not solve the problem.