ASKProxima m9 User Guide

You can change the elevation angle of the projector in a range of 0 to 12 degrees. You can 
also make fine adjustments to the left and right side elevation angle when necessary.

Lift up the front of the projector and press the 
release button.

z This causes the elevation adjustment foot to drop 

from the bottom of the projector.

z Be sure to press the release button before trying to 

lower the elevation adjustment foot. Pulling on the 
foot without pressing the release lever can damage 
the foot.

While holding down the release button, raise and 
lower the front of the projector until the elevation adjustment foot is approximately the 
length you need.

Release the release button to lock the elevation adjustment foot in its current position.

Use the left and right adjustment feet to further fine adjust the elevation angle.

z The left and right adjustment feet are for fine adjustment only. Do not try to rotate them 

too far. Doing so can cause an adjustment foot to detach. Tightening an adjustment foot 
too strongly can cause it to become stuck.

z To retract the elevation adjustment foot, hold down the release button and slide the 

elevation adjustment foot back into the projector. Never try to forcibly change the elevation 
adjustment foot position without pressing the release button.

In the case of rear projection, left/right orientation is opposite that of front projection, so you 
need to configure the setup menu accordingly. For more detailed operation information, see the 
Reference Guide on the CD-ROM that comes with the projector.

ASK M9_UG_E.book  Page 8  Tuesday, October 23, 2007  5:32 PM