ASKProxima a6 compact User Guide
USER GUIDE
XGA LCD PROJECTOR
16
adjustable feet in the front, so that the image can be shifted to a desired
height on the wall. Tilt the projector body in the desired position and
press the foot-release buttons. If necessary, fine adjust the height by
screwing the feet either direction.
height on the wall. Tilt the projector body in the desired position and
press the foot-release buttons. If necessary, fine adjust the height by
screwing the feet either direction.
2. RESET in most cases automatically adjusts the image position, width
(FREQUENCY) and stability (TUNE). If RESET fails to adjust the image
correctly, see FREQUENCY, POSITION and TUNE below. RESET is
automatically activated when a new source is connected.
correctly, see FREQUENCY, POSITION and TUNE below. RESET is
automatically activated when a new source is connected.
3. CONTRAST and BRIGHTNESS may be adjusted according to your
personal taste, the image and the viewing conditions. The controls are
directly accessible on the remote control and on the projector keyboard.
directly accessible on the remote control and on the projector keyboard.
4. FREQUENCY. The frequency controls the width of the image. A wrong
frequency setting can be seen as equally spaced, vertical stripes or
irregularities in the pattern displayed. Press the MENU key, SET-UP,
FREQUENCY and press ENTER. Adjust the value up or down using the
trackball or keyboard cursor controls, observing that the amount of
vertical stripes reduces, until the distortion is gone. You may still have an
unstable image, please see the next section.
irregularities in the pattern displayed. Press the MENU key, SET-UP,
FREQUENCY and press ENTER. Adjust the value up or down using the
trackball or keyboard cursor controls, observing that the amount of
vertical stripes reduces, until the distortion is gone. You may still have an
unstable image, please see the next section.
5. POSITION the image correctly by accessing SET-UP, POSITION, then
press ENTER and adjust position with the trackball or keyboard cursor
controls
controls
6. TUNE the image for a stable projection. In the menu, select SET-UP,
TUNE and press ENTER. Adjust stability using the trackball.
Set-up should be done once with the source(s) you are using most
frequently. Allow some minutes for the unit to warm up before adjusting the
settings. Most settings will be memorized individually for each source for
future use.
frequently. Allow some minutes for the unit to warm up before adjusting the
settings. Most settings will be memorized individually for each source for
future use.