Zhone 6381-a4-200 User Guide
6381-A4 Router Users Guide
47
5.
In the Bridge Settings section, select the Encapsulation Type (LLC or VC) as supplied by
your ISP.
your ISP.
If you are unsure, just leave the default settings.
Encapsulation
The technique used by layered protocols in which a layer adds header information
to the protocol data unit (PDU) from the layer above. As an example, in Internet
terminology, a packet would contain a header from the data link layer, followed by
a header from the network layer (IP), followed by a header from the transport
layer (TCP), followed by the application protocol data. Two encapsulation options
are provided:
to the protocol data unit (PDU) from the layer above. As an example, in Internet
terminology, a packet would contain a header from the data link layer, followed by
a header from the network layer (IP), followed by a header from the transport
layer (TCP), followed by the application protocol data. Two encapsulation options
are provided:
•
Logical Link Control (LLC)
•
Virtual Channel (VC).
Select LAN
Select the LAN group for the bridged connection. The following options are
available:
available:
•
LAN Group 1
•
LAN Group 2
•
LAN Group 3
•
None
This bridged connection will be added to the selected LAN group. If you select
None, the connection is not added to any LAN group but to the Interfaces box on
the LAN Configuration page which can be configured to a LAN group on the same
page.
None, the connection is not added to any LAN group but to the Interfaces box on
the LAN Configuration page which can be configured to a LAN group on the same
page.
6.
In the PVC Settings section, enter values for VPI and VCI as supplied by your ISP
For more information, please see PVC Settings from the PPPoE Setup procedure.
7.
Select the quality of service (QOS).
Leave the default value if your ISP did not provide this information. Depending on the QoS
you select, you may also enter:
you select, you may also enter:
• PCR (Peak Cell Rate)
• SCR (Sustainable Cell Rate)
• MBS (Maximum Burst Size)
• CDVT (Cell Delay Variation Tolerance)
• SCR (Sustainable Cell Rate)
• MBS (Maximum Burst Size)
• CDVT (Cell Delay Variation Tolerance)
8.
To complete the connection click Apply.
The Apply button will temporarily save this connection. To make the change permanent, click
Tools (at the top of the page) and select System Commands. On the System Commands
page, click Save All.
Tools (at the top of the page) and select System Commands. On the System Commands
page, click Save All.