Zhone 6381-a4-200 User Guide
6381-A4 Router Users Guide
49
The name must not have spaces and cannot begin with numbers.
4.
Select NAT and Firewall if you want them active for this connection.
Firewall and NAT services must be enabled.
5.
In the PVC section, select the VPI and VCI settings as provided by your ISP.
For more information, please see PVC Settings from the PPPoE Setup procedure.
6.
Enter the IP address and subnet mask, the address of the ARP Server and the address of
the Default Gateway as provided by your ISP.
the Default Gateway as provided by your ISP.
IP Address
IP address of the CLIP connection provided by your ISP.
Mask
Subnet mask provided by your ISP.
ARP Server
IP address of the Address Resolution Protocol (ARP) server provided by your ISP.
Default Gateway
If checked, this WAN connection acts as the default gateway to the Internet.
7.
Select the quality of service (QOS).
Leave the default value if your ISP did not provide this information. Depending on the QoS
you select, you may also enter:
you select, you may also enter:
• PCR (Peak Cell Rate)
• SCR (Sustainable Cell Rate)
• MBS (Maximum Burst Size)
• CDVT (Cell Delay Variation Tolerance)
• SCR (Sustainable Cell Rate)
• MBS (Maximum Burst Size)
• CDVT (Cell Delay Variation Tolerance)
8.
To complete the connection click Apply.
The Apply button will temporarily save this connection. To make the change permanent,
click Tools (at the top of the page) and select System Commands. On the System
Commands page, click Save All.
click Tools (at the top of the page) and select System Commands. On the System
Commands page, click Save All.