Amana mvwc300v Installation Instruction

 Leveling your washer properly reduces excess 

noise and vibration. 

Prop up front of washer about 4" (102 mm) with a wood block or 

similar object that will support weight of washer. Then screw jam 

nut onto each foot to within 1" (25 mm) of foot base.

Screw feet into threaded holes at front  

corners of washer until jam nuts touch washer, but are not tight. 

Tilt washer back, remove wood block. Gently lower washer to 

floor and slide washer to its final location. Remove cardboard 

used to protect floor. 

Laundry Tub           Standpipe             Wall

Tilt washer forward; self-adjusting rear feet will click into place. 

Gently lower washer to floor.

Place a level on top edges of washer, checking each side 

and front. Rock washer back and forth to make sure all four 

feet make solid contact with floor. If not level, tip washer and 

adjust feet up or down, repeating as necessary. 

       Not Level 

            

LEVEL                    Not Level

Place level here

Secure drain hose to laundry tub leg, drain standpipe, or inlet 

hoses for wall standpipe with beaded tie strap (A). This will 

help reduce the chance of drain water splashing on the floor.