Konica Minolta mc1690mf User Guide
Sending a Fax Manually
3-18
3
Pick up the handset and check that the dial tone can be heard.
4
Specify the fax number of the recipient by using the telephone to dial the
fax number.
fax number.
"
The fax number of the recipient can also specified using the keypad in
the control panel of this machine.
the control panel of this machine.
"
If Pulse is selected as the telephone line type, press the key to tem-
porarily change the line type to Tone.
porarily change the line type to Tone.
5
After finishing talking on the phone, the recipient should press the neces-
sary key to start receiving the fax.
Once the recipient’s fax machine is ready, a beep is sounded.
sary key to start receiving the fax.
Once the recipient’s fax machine is ready, a beep is sounded.
6
Press the Start key to begin scanning and sending the fax.
7
Replace the handset to its cradle.
"
To stop the transmission, press the Stop/Reset key. A message
appears, requesting confirmation to cancel the setting. Select
appears, requesting confirmation to cancel the setting. Select
YES
,
and then press the Select key.
Sending a Fax Manually Using the On Hook Key
"
Manual transmission cannot be used together with duplex (dou-
ble-sided) document transmission.
ble-sided) document transmission.
1
Load the document into the ADF.
"
When sending a fax manually, load the document into the ADF. An
error will occur if the document is placed on the original glass.
error will occur if the document is placed on the original glass.
"
For details on loading the document into the ADF, refer to “Sending a
Fax Using the ADF” on page 3-2.
Fax Using the ADF” on page 3-2.
2
If desired, adjust the image quality.
"
The document image quality can be adjusted. For details, refer to
“Adjusting the Image Quality” on page 3-6.
“Adjusting the Image Quality” on page 3-6.
3
Press the On hook key.
4
Specify the fax number of the recipient.
"
The keys for registered destinations can be used even if the On hook
key has been pressed. For details, refer to “Specifying a Recipient” on
page 3-7. (Group dial destinations cannot be specified.)
key has been pressed. For details, refer to “Specifying a Recipient” on
page 3-7. (Group dial destinations cannot be specified.)
"
If Pulse is selected as the telephone line type, press the key to tem-
porarily change the line type to Tone.
porarily change the line type to Tone.