Hitachi dz-mv200a Owner's Manual

English

Use the provided AV input/output cable to connect the DVD video camera/recorder to a TV as follows:

Turn the TV on and set the input selector to
“VCR” whichever applicable Video input.

Refer to the TV instruction manual for how to
switch the TV input.

Set the power switch to “   VIDEO” or
“

 PHOTO” to turn the DVD video camera/

recorder on.

The image that the DVD video camera/recorder
is seeing will appear on the TV screen. You can
also monitor the image on the LCD screen or
viewfinder of the DVD video camera/recorder.

Perform playback or recording.

Turn down TV volume in record mode, or feed-
back could result.

Note: The infrared remote control is useful when
operating the DVD video camera/recorder while
viewing an image on TV screen. However, if you
use a Hitachi VCR, the remote control may inad-
vertently operate the VCR if it is near the DVD video
camera/recorder. To prevent this, set the remote
control code of the VCR to a position other than
“VCR2”.
Note: Information that the DVD video camera/
recorder is recording will appear on the TV screen:
You can also display only part of information or
switch off the display. Refer to “Switching On-
Screen Display Output On or Off” on page 62, and
press the DISPLAY button to switch the display sta-
tus.
Note: When copy-guarded disc is played back,
no image will appear on TV screen.
Note: If you use TV with wide mode (aspect ratio
16:9) and set the TV to the wide mode, the Disc
Navigation screen may malfunction. If this hap-
pens, release the wide mode setting on TV (see
the TV instruction manual for releasing the wide
mode).