Haier xqb50-20 User Manual

1

Loosen the fastening screws of the back cover,unpack 

the back cover gently,  avoiding to break the clip claw.

Figure 1

3

Stretch out the drain hose to the right of the frame 

from the groove. Fasten it in the base frame with the 
drain hose support, and fasten the screws.Then hang
the hook in the drain hose, and hang the drain hose in
 the hole of the cabinet. (Figure 3)

2

Take the drain hose from the cabinet, make the mouth of

it flat a little, dismantle the pothook, loosen the fastening
screws, dismantle the drain hose support ,and pull the drain 
hose into the cabinet from the left of the base.

Figure 2

Screws

Back cover

( Figure 3 )

(Figure 4)

Lower hook

Upper  tab

Side tab

Make the mouth of the
 drain hose flat, take off
 the pothook.

Drain hose frame

Screws

A

1.Never let the drain hose exceed 10cm above the 
ground. If the timeof draining is too long, the washing
 machine will stop in the midway.

3.

If the drain hose is too long, cut it at mid point. To make

 smooth drainage, cut the front end of the hose slantingly.

4.

If extra drain hose is needed, please make separate

 purchase. The inner diameter of the extra  hose shall
 not  less than 30mm, and the  length  shall not exceed 
1.5m.

5. If the extra hose is too long,cut it either at A or 

at B 

<10cm

A

B

>   30mm

<1.5m

How to change the direction of the drain hose

Usage of the drain hose

The drainage shall be smooth with  the drain hose.

2.Do not step on  or  press  the  drain hose.

( Figure 2 )

4

Install the back cover. Hang the under side of the

 back cover on the cabinet firstly, then push the left 
,  the right tab  and the upside into the cabinet.
Do not do it strongly, and fasten the screws.
 (Figure 4)