Haier wqp12-abm User Manual

- Make sure that the plug for the appliance

  is inserted into the wall socket.

- Make sure that the water supply is turned

  on to full pressure.

- Load the dishwasher (see the section

  entitled,"Loading the Dishwasher").

- Pour in the detergent (see the section

  entitled,"Salt,Dergent and Rinse Aid").

- Turn the knob located on the right of the

  control panel in the clockwise direction

  until the number or symbol for the cycle

  setting is aligned with the reference mark

  (see the  section entitled,"Wash Cycle Table").

- Press the ON-OFF button,and the ON-OFF

  light will turn on.At this point,the wash  cycle

  will begin.

Premise:A cycle that is underway can only be

modified if it has only been running for a short

time.Otherwise, the detergent may have al-

ready been used,and the appliance may have

already drained the wash water,If this is the

case,the detergent dispenser must be refilled

(see the paragraph entitled,"Loading the

Detergent").

Press the ON-OFF button,and the ON light

will turn off.Rotate the knob in the clockwise

direction to the desired cycle setting(see the

section entitled.:Starting a wash cycle

The wash cycle can be interrupted by pressing

the ON-OFF button.You can then load addi-

tional dishes and turn the appliance back on.

The cycle will start where it left off.

Wait a few  minutes before unloading the dish-

washer to avoid handling the dishes and uten-

sils while they are still hot and more suscep-

tible to breakage.They will also dry better.

This button(see "close-up View - Control

Panel",letter"G")is used for normally dirty

dishes, pots and pans.It is standard daily cycle.

This button(see "close-up View - Control

Panel",letter"H") make it possible to wash

dishes using only the upper rack if there are

not enough dishes for a full load.This will al-

low you to save on water and eletrical energy.

This button(see "close-up View - Control Panel",

letter "I") ,when pressed with wash cycle 4

(glassware) make it  possible to run the wash

cycle at a lower temperature (50

) and

eliminates the drying phase.

It is important to try and run the dishwasher

  when  it is fully loaded to save on enery.In

  order to prevent odors from forming and food

  from caking onto the dishes,you can run the

  hold cycle.

- Choose the right wash cycle: the choice of

  cycle depends on the type of dishware, cook

  ware and utensils being washed and how dirty

  they are.

- Use the right amount of detergent: if you use

  too much detergent, the result will not be

  cleaner dishes,but,rather,a greater negative

  impact on the enviroment.

- There is no untility in rinsing dishes ,cook

  ware and untensils before placing them in the

  dishwasher.

It can be used before setting any of the wash

cycles, except for the intensive cycles (if in-

cluded in the wash cycle table ).  Please keep

in mind that the amount of degertent should also

be cut in half.

When the knob stops turning and is aligned

with a STOP mark(see figure),the cycle has

finished.Turn off the appliance using the ON-

OFF button,turn off the water supply and open

the door of thr dishwasher.

STOP