Revel sub15 User Guide
Figure 11. How to connect the
ULTIMA SUB-15/LE-1
powered subwoofer system to a
home theater multi-channel
controller using the LE-1’s
internal FM-2 crossover.
ULTIMA SUB-15/LE-1
powered subwoofer system to a
home theater multi-channel
controller using the LE-1’s
internal FM-2 crossover.
CONNECTIONS (Continued)
SUB-15/LE-1 AND A MULTI-CHANNEL CONTROLLER
USING THE LE-1’s CROSSOVER
USING THE LE-1’s CROSSOVER
In this application, the ULTIMA SUB-15/LE-1’s internal FM-2
crossover is used to interconnect a home theater multi-channel con-
troller, as shown in Figure 11.
crossover is used to interconnect a home theater multi-channel con-
troller, as shown in Figure 11.
ULTIMA SUB-15/LE-1
Owner’s Manual
20
LE-1 Rear Panel
F
U S E
F
US
E
Caution: Connect to Revel Subwoofers only!
Floating Ground. Do not connect loudspeaker
outputs to any grounded equipment.
No user servicable parts inside.
For service contact Revel or an authorized dealer.
Refer to Owner's Manual for proper operating
instructions and safety precautions.
Floating Ground. Do not connect loudspeaker
outputs to any grounded equipment.
No user servicable parts inside.
For service contact Revel or an authorized dealer.
Refer to Owner's Manual for proper operating
instructions and safety precautions.
Serial No.
Freq Eq
In/Out
Music Sensor
Bypass -
Press & Hold
Five Seconds
In/Out
Music Sensor
Bypass -
Press & Hold
Five Seconds
Right Input
Right Output to main amplifier
Left Output to main amplifier Out to LE-1
Left Input
Inputs
Balanced
Balanced
Unbalanced
Sub # 1
Sub # 2
Revel
Northridge, CA/U.S.A.
Designed & Manufactured in U.S.A.
Northridge, CA/U.S.A.
Designed & Manufactured in U.S.A.
REVEL LE-1
LOW FREQUENCY
ELECTRONICS SYSTEM
LOW FREQUENCY
ELECTRONICS SYSTEM
Use T12A
250V Fuse
Only!
250V Fuse
Only!
CAUTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION:
RISK DE CHOC ELECTRIQUE
NE PAS OUVRIR
NRTL/C
UL-6500
120VAC ~ 60 Hz 720W
Power
Trigger
In
Crossover
Low Pass
Frequency (Hz)
Frequency (Hz)
High Pass
Frequency (Hz)
Frequency (Hz)
Revel FM-2
Filter Module
Filter Module
Enabled
Disabled
50
60
40
70
30
80
50
60
40
70
30
80
SUB-15 Rear Panel
Must be used
in conjunction with
Revel electronics.
in conjunction with
Revel electronics.
Northridge, California
Made in U.S.A.
Made in U.S.A.
Serial No.
Multi-Channel Controller (Decoder)
(rear)
Left Output
FRONT/MAIN
Right Output
Left Output
REAR
Right Output
Left Output
SURROUND/SIDE
Right Output
CENTER Output
SUB/LFE Output
NOTE: Set Controller outputs to full-
range L/R Front and no SUB.
If applicable, set all other channels
to pass 80 Hz and above. Below
80 Hz, signals will route to SUB-15.
range L/R Front and no SUB.
If applicable, set all other channels
to pass 80 Hz and above. Below
80 Hz, signals will route to SUB-15.
Main Amplifier
(rear)
To Main Speakers
Left Input
Left
Right
Right Input
or
or
or
or
NOTE: Enable Crossover
(i.e., switch is OUT).
Crossover
Enabled
Disabled