Whirlpool WGD94HEX User Guide

2.  Align the two hooks on the front of the drying rack with 

the holes in the dryer door opening and press down fully 

into holes. Rest the rear support on the dryer back ledge.  

To obtain a drying rack for your dryer, follow the instructions 

included in your dryer drum. Remove and discard any  

packing material before use. 
Use the Drying Rack for items that you do not want to 

tumble dry, such as sweaters and tennis shoes. When you 

use the drying rack, the drum continues to turn, but the rack 

remains stationary. 
The drying rack is intended for use with the Manual Dry/

Timed Dry cycles only. The drying rack cannot be used  

with Automatic cycles.

IMPORTANT: Do not remove the lint screen. 
1.  Open dryer door. 

3.  Place wet items on top of the drying rack. Allow space 

around items for air to circulate. The drying rack does 

not move, but the drum will rotate. Make sure items do 

not hang over the edges or between drying rack grille. 

4.  Close the door. 
5.  Select a Timed Dry/Air Only, or Low Temperature cycle. 

Items containing foam, rubber, or plastic must be dried 

on a clothesline or by using the Air Only setting. 

6.  When the cycle is selected, the Estimated Time  

Remaining display shows the default time. You can 

change the actual time in the cycle by increasing or 

decreasing the cycle time. 

7.  Start the dryer. 
NOTE: Check the lint screen and remove any lint  

accumulated from items dried on the drying rack  

after the cycle is finished. 

Temperature

Cycle Signal

Dryness Level Garment #

for auto cycles for refresh cycles

Air Only

Extra Low

Medium
Low

High

Less Dry

Normal Dry

More Dry

6 - 7

8 - 9

2 - 3
1

4 - 5

Soft
Off

Loud

Wrinkle

Shield

Done

Wet

Damp Cool

Down

Steam Static

Reduce

Check Lint Screen Sensing

Estimated Time Remaining

Timed Dry Adjust

The Cycle Status Indicators show the progress of a cycle. 

Check Lint Screen
  The Check Lint Screen indicator will light when the dryer  

is turned on as a reminder to clean the lint screen before  

each load. 

Sensing
  The Sensing indicator will light during Eco Auto Cycles to  

indicate that the moisture sensor on the dryer is operating. 

This indicator will not light during Manual Cycles or options 

such as Wrinkle Shield

™

.

Wet
  The load is still wet and/or the cycle just started.   

Damp
  This indicator shows that the load is partially dried and items 

that you may wish to hang up or iron while still damp may 

removed. 

Cool Down
  The dryer has finished drying with heat, and is now tumbling 

the load without heat to cool it down and reduce wrinkling.   

Steam (on some models)
  This indicator will light when the Steam function is active. 

NOTE: Steam is not available on all models or on all cycles. 

Static Reduce (on some models)
  This indicator will light when the Static Reduce function is 

active. 

NOTE: Static Reduce is not available on all models or 

on all cycles. 

Done
  This will indicate that the selected cycle has ended and the 

load may be removed from the dryer. If the Wrinkle Shield 

option has been selected, the dryer may continue to tumble 

the load, even if the Done indicator is lit.  

  This indicator will light if the Wrinkle Shield option has been 

selected and is running. The dryer will continue to tumble the 

load for up to 150 minutes after the cycle has ended.  

11-cycle model shown